Coir Buster Industrial
Now a coir block feeder system that will greatly reduce labor and provide a steady flow of material to keep the Coirbuster at maximum output. The Coirbuster system is a patented design that gently decompresses the blocks apart with minimum damage to coir fibers. Unlike hammer mills that use high RPM the Coirbuster moves the block material in a figure eight cycle that gently rubs itself apart. All material goes through a sizing screen( size to be determined by customer) to a 10 foot auger that moves material to the 20 foot hydration auger. The material can be ready for use at the discharge point.
Coirbuster Specifications
230 volt 3 phase draws 68 amps
Decompresses 1 pallet of coir 4 or 5 to 1 ratio 12x12x6 blocks in approximately 12 minutes
20 foot x 14 inch hydration auger with 2 each 1 inch water pipes with on/ off valves
230 volt 3 phase draws 22 amps
Coir block feeder unit will provide a steady flow of blocks to keep the coirbuster at maximum output.
230 volt 3 phase motor on the chain conveyor draws 6.8 amps
230 volt 3 phase motor on the leveling drum (16 inches in diameter) draws 22 amps
Hydraulic lift gate volt 3 phase draws 6.8 amps Total amp draw on system 125.6 amps
Note decompression rates may vary depending on moisture content, block size and compression rates.
![](http://ellisproducts.com/wp-content/uploads/2019/05/DSC00938-300x168-1.jpg)
![](http://ellisproducts.com/wp-content/uploads/2019/05/Capture.png)
Coirbuster Max Industrial System
Coir Buster System Vancouver Canada
![](http://ellisproducts.com/wp-content/uploads/2019/05/Coir-Buster-Machine-From-Ellis-Products-2.jpg)
![](http://ellisproducts.com/wp-content/uploads/2019/05/Coir-Buster-Machine-From-Ellis-Products-1.jpg)
Copyright ©
Copyright © 2019 Mitchell Ellis Products of Semmes Al, Inc. All rights reserved
Contact
Mitchell Ellis Products Inc
PO Box 628 Semmes, Alabama 36575
Phone : (251) 649-6466
Email : info@ellisproducts.com