Select Page

Coir Buster Industrial

Now a coir block feeder system that will greatly reduce labor and provide a steady flow of material to keep the Coirbuster at maximum output. The Coirbuster system is a pa-tented design that gently decompresses the blocks apart with mini-um damage to coir fibers. Unlike hammer mills that use high RPM the Coirbuster moves the block material in a figure eight cycle that gently rubs itself apart. All material goes through a sizing screen( size to be determined by customer) to a 10 foot auger that moves material to the 20 foot hydration auger. The material can be ready for use at the discharge point.
Coirbuster Specifications
230 volt 3 phase draws 68 amps
Decompresses 1 pallet of coir 4 or 5 to 1 ratio 12x12x6 blocks in approximately 12 minutes
20 foot x 14 inch hydration auger with 2 each 1 inch water pipes with on/ off valves
230 volt 3 phase draws 22 amps
Coir block feeder unit will provide a steady flow of blocks to keep the coirbuster at maximum output.
230 volt 3 phase motor on the chain conveyor draws 6.8 amps
230 volt 3 phase motor on the leveling drum (16 inches in diameter) draws 22 amps
Hydraulic lift gate volt 3 phase draws 6.8 amps Total amp draw on system 125.6 amps

Note decompression rates may vary depending on moisture content, block size and compression rates.

Coirbuster Max Industrial System

Coir Buster System Vancouver Canada

Copyright ©

Copyright © 2016 Mitchell Ellis Products of Semmes Al, Inc. All rights reserved

Contact

Mitchell Ellis Products Inc

PO Box 628 Semmes, Alabama 36575

Phone : (251) 649-6466
Fax : (251) 649-6602
Email : info@ellisproducts.com